Pull the half shaft out before you undo any bolts.
+38 is stock Evo offset. They clear with no issues at all.
Most Evo wheels are 17x8, and the X's are 18x8.5 with the same offset.
Does anyone have the part numbers for the 380 ones? I'll see if I can compare them to the Eclipse ones.
Not sure yet, just waiting for mine to be shipped. Will report back when they're fitted.
I found a source for the window washer nozzles that look to be identical to the 380 ones. These ones produce a mist rather than two...
I routed mine up into the fusebox and off the main fuse from there.
My fusebox required modification, however I'm running 1/0 oversized, so it's a...
Bolt it to the floor.
I can't see any neutral light flashing. Check the cabin fuses for the reverse light, it's shared with the TCU.
Have had this go before and it...
I have a Legnum VR4 towbar out of the car if anyone wants photos and measurements so they can get one made up.
I have an Evo 3 plate type centre. An ex-member on here put an Evo 3 plate centre into his open diff as well, it worked fine.
The LSD centres all...
An auto ECU is fine. Just get it reflashed.
FL auto throttle body is the largest one of the lot. PFL auto one has all the traction control stuff.
Be aware that when you swap to a manual...
You can use benchtop joiners as well. They have C shaped fittings on either end with a threaded rod - they work a treat.
It won't. You have different sized pistons, stroke, and so on - and the 6G crank would be longer as a result of this.
My one is the MR283263. ASA doesn't list a revised part number but Amayama shows another part number too.
The part number applies to all 8th gen...
I think mine had the recall done but has done the same kind of thing.
If you have a manual clock face you can swap that across to hide the auto lights and retain your mileage.
Just requires taking the plastic off the...
I pull the cabin fuse. Without the ECU controlling the pump, from memory it doesn't prime.
Will test that when I get time though.
And you're best to pull the engine first as you might order bearings, then find that the mains tunnel needs to be ground - which changes the...
All 3 sets of numbers go together. If you're replacing the mains bearings you should do conrod bearings and the thrust bearing.
The snippet that...