naughtika
OzVR4 Stalker
I can get the BKR7EIX plugs for $12 each.. plus postage to where ever you are..
naughtika
OzVR4 Stalker
fellas, for some reason the price have gone up to $12.15 each.. they are 1.1mm gapped so you'll just have to re-gap them..
can i please get a PM of who's definitely ordering, I'm picking them up on Wednesday and hopefully I can send it on the same day too..
can i please get a PM of who's definitely ordering, I'm picking them up on Wednesday and hopefully I can send it on the same day too..
naughtika
OzVR4 Stalker
fellas.. I dont think I can get a set of pluggies any more 
branch's closing down..
branch's closing down..
G
Guest
Unregistered
- Thread starter
- #128
Not sure if someone have informed already this but those damn expensive seals are littlebit cheaper at Camskills.
MODEL NAME: MITSUBISHI OE PARTS Plug Seals - Legnum VR4
PRICE: RRP £112.73
OUR PRICE £25.49
*32.31 Euro (EUR) approx
http://www.camskill.co.uk/products.php?plid=m22b0s1399p11349
G
Guest
Unregistered
- Thread starter
- #129
Thet started to stock them after I asked them for a price when I found out they were £15 each at the dealer
G
Guest
Unregistered
- Thread starter
- #130
i have bought 2 rocker cover gaskets, 6 spark plug tube seals, and 18 rocker cover washer seals,
$160nzd
the rubber washers should be changed when you remove the covers,
there $4.20+gst each at mitsi... you need 18 LOL!
new gaskets from mitsi...
rocker cover, - MD174560
$39.16+gst X 2
spark plug hole gasket, - MD178940
$13.34+gst X 6
PCV valve Gasket, - MD179909
$7.11+gst X 1
gst=12.5%
all prices are NZD
.
$160nzd
the rubber washers should be changed when you remove the covers,
there $4.20+gst each at mitsi... you need 18 LOL!
new gaskets from mitsi...
rocker cover, - MD174560
$39.16+gst X 2
spark plug hole gasket, - MD178940
$13.34+gst X 6
PCV valve Gasket, - MD179909
$7.11+gst X 1
gst=12.5%
all prices are NZD
.
SiliconAngel
1 AYC Bar
You really shouldn't be paying more than ¥500 each plus shipping, which is what you can get them from Mitsubishi Japan for. That's around $40 all up to your door with the right supplier
Part number for these is MD327253. I strongly suspect they're a great deal cheaper than this from Japan - I'll look into it.
Dr_Josh001
Leaving Skid Marks
Just changed my plugs out with the Iridium ones. As I am a novice and don't know what a bad plug is how does the old one look?
naughtika
OzVR4 Stalker
seems like a used normally used plug.. have you got a better shot of it? like looking down (in a bit of an angle) on the electrode..
also did that came from the rear bank?
also did that came from the rear bank?
Dr_Josh001
Leaving Skid Marks
Not sure but they all pretty much look like this.
How does this look?
How does this look?
bradc
1 AYC Bar
they look like they are in reasonable condition, they weren't on their last legs at least.
naughtika
OzVR4 Stalker
Doc, if that plug is iridium.. IMO you got nothing to worry about.. it looks like its doing its job pretty good..
Dr_Josh001
Leaving Skid Marks
The photo is just the old copper core one. The Iridium ones are the new ones I put in.
eddyvr4
Leaving Skid Marks
One point to note, i just put new plugs (thanks Trav) in my stock 2001 legnum, and the ones i took out were completely eroded down on the centre electrode, with gaps up to 1.4mm on the rear bank. so i would advise new owners to check/replace plugs ASAP on reciept of the car as highly reccomended.
No wonder i was having the car bog down running even slightly elevated boost levels...
No wonder i was having the car bog down running even slightly elevated boost levels...
changed mine on sunday, big improvement over the old ones (which weren't all that bad really) im assuming due to gapping difference
