Kenneth
1 AYC Bar
The VR-4 does quite well for grip, so most probably don't notice the fact that the non-AYC diff is open. Also the fact that it has a viscous coupling in the centre means that even if you get one rear wheel spinning, the VCU (Viscous coupling unit) will get the front moving to take up the slack.
If you want a cheap LSD, you have some options. The easiest (my step father says you either invest money, or time... choose the one you have most of) is to get either a cusco unit (expensive) or ask around the rally teams and get a 2nd hand standard Evo plate LSD (the bit that goes inside the diff, not the casing, you already have that). I Picked up an evo IX plate LSD with literally 50km on it for $500NZ as the rally team just cant compete with it in the car, so remove it right away.
If you have more time than money, get yourself the Viscous LSD internals from a RVR. You will need to swap the crown gear and get some custom shafts done. Depending on how easy you can get the shafts done to how expensive this option is. You also need the CVs for the RVR diff as you will need parts to make your custom shafts.
I was going to go down this route, but the Evo IX diff was cheap enough to have me discard it. (though I have all the parts)
Make sure you get the diff assembled properly though, if you don't it will just destroy itself (gear contact pattern, bearing pre-loads etc)
Hope that is of some help.
If you want a cheap LSD, you have some options. The easiest (my step father says you either invest money, or time... choose the one you have most of) is to get either a cusco unit (expensive) or ask around the rally teams and get a 2nd hand standard Evo plate LSD (the bit that goes inside the diff, not the casing, you already have that). I Picked up an evo IX plate LSD with literally 50km on it for $500NZ as the rally team just cant compete with it in the car, so remove it right away.
If you have more time than money, get yourself the Viscous LSD internals from a RVR. You will need to swap the crown gear and get some custom shafts done. Depending on how easy you can get the shafts done to how expensive this option is. You also need the CVs for the RVR diff as you will need parts to make your custom shafts.
I was going to go down this route, but the Evo IX diff was cheap enough to have me discard it. (though I have all the parts)
Make sure you get the diff assembled properly though, if you don't it will just destroy itself (gear contact pattern, bearing pre-loads etc)
Hope that is of some help.