Sold NSW Kelford 270 degree regrinds Cams

[rbrtpalin]

Hi all,
Moved up to billets recently, so my regrinds are for sale.
They are Kelfords and came in at 270 degrees with 10.3mm lift.
Only had them in for ~ 10k km.
Nice and lumpy and achieved 245kw ATW with minimal mods in these. (98)
You will need to shim though to minimise lifter tick etc.
asking $550 and happy to ship wherever at buyers expense.

 

[BCX]

How much did you need to shim the lifters?

 

[rbrtpalin]

Ahhh, can’t remember. Started at 0.6mm I think and ended up with something like 1.1 or 1.2mm. I’ll have to check receipts for the actual sizing if you need it. Went the larger size as was still a little ticky on start up. Seemed to quiet down after that.

 

[BCX]

And that was my next question... how noisy were the lifters?

 

[rbrtpalin]

Not too bad. Depends on your standard though. With the bigger shims there was minimal noise. A bit on start up, like 1 lifter was dry or something. But that could have been age related. Once warm was good.

 

[rbrtpalin]

Sold.