New Workshop Manuals

Kitty's VR4

1 AYC Bar
Lifetime Member
Location
NSW
First Name
Kat
Drive
Legnum, Audi RS6
Hi guys/leggie ladies,

to any of you that have received your new manuals, can I ask a huge favour. I'm currently preparing a HOW TO - replace your front hubs/wheel bearings, I replaced mine last week.

I didn't have the torque setting for the following, can someone supply the correct torque figures from their manuals, pretty please:

32mm Drive Shaft Split Pin Nut = 195Nm - 255Nm

17mm Bollts x4 that retain the Hub/Bearing assembly in the Hub Carrier = 88Nm

17mm Bolts x2 that retain the Caliper assembly on the Hub Carrier = 100Nm

I used the torque settings from my celica GT4 Manuals because they are a very similar setup (Yea I know I'm a naughty lil girl)

Your assistance will be truly appreciated as I want to ensure the information is absolutely correct in the "HOW TO" guide, as its a reference for other members.

Kat


Ok just did a bit of digging on ClubVR4 and found torque setting for 32mm nut = 195Nm-255Nm, I did mine to 240Nm as per GT4 settings, so i'm off the hook on that one.
Yea three ticks for me, did the rest at 100Nm, so nothings going to fall off
 

Kitty's VR4

1 AYC Bar
Lifetime Member
Location
NSW
First Name
Kat
Drive
Legnum, Audi RS6
Thanks so much Brad...

No matter what they say...

:drool: "Your a legendary administrator" :drool:
I appreciate the way you handle the flock
 
Top Bottom