Power cables through firewall

paavank

Idling at the Lights
Location
Auckland
First Name
Paavan
Drive
2000 Mitsubishi Galant VR4
I've got a 2000 galant vr4 and I'm installing a sub woofer in the boot. Running cables through the panels is easy but I can't seem to get through my firewall. Does anyone know how to get through with out cutting or drilling?
Preferably would like to go through driver side too.
 

mezje

1 AYC Bar
Moderator
Premium Member
Location
Melbourne
First Name
Maxim
Drive
1998 Galant VR4 Manual
There are grommets on either side that go in to the wheel well and then into the cabin.
 

paavank

Idling at the Lights
Location
Auckland
First Name
Paavan
Drive
2000 Mitsubishi Galant VR4
There are grommets on either side that go in to the wheel well and then into the cabin.
Thank you, other forums have said the same but I am finding difficult finding the grommets.
 

paavank

Idling at the Lights
Location
Auckland
First Name
Paavan
Drive
2000 Mitsubishi Galant VR4
I've taken off my wheel, wheel well and fender and I cannot see where this grommet it. Please help.

20221123_171939.jpg
 

Baba Galant

1 AYC Bar
Lifetime Member
Location
Melbourne
First Name
John
Drive
Galant VR4 twin turbo 1997
I had this too when running a ower cable from battery to fuel pump
I went in through the engine bay, passenger side below the ABS ASC relays. It leads to behind the glove box.
It's not easy but I think the driver's side is harder, it has to make a turn to get through.
If you must use a heavy cable for doof doof performance pick a good quality grommet and a stepped tapered drill, it will save a lot of effort.
 
Top Bottom