replaced audio.. Now amp goes into safety mode

Riley

Leaving Skid Marks
Location
QLD
First Name
Riley
Drive
96 Legnum vr4
the gain setting is more relevant to the equipment and the situation, basically you dont want to be able to turn the volume up to the point where your speakers are being damaged

that said your amp shouldnt go into protect just because the gain has been set too high. use a multi meter to measure the impedance (ohms) of the speakers connected to the amp and the amount of power the amp is getting

if all else fails you may need to borrow an amp to wire in temporarily, this way you can determine if the problem is with your amp or somewhere else in the system
 

-T8-

Leaving Skid Marks
Location
NSW
First Name
Tate
Drive
WRX CSE5, 7g galant
all good ideas, got the day off tomorrow, will have a look.. thanks for the advice guys
 
Top Bottom