So i finally got the engine out for bearing changes but a checklist..

jlx

Idling at the Lights
Lifetime Member
Location
Finland
First Name
jan
Drive
Legnum vr 97
So while i have the engine out for crankshaft/Conrod bearing change,
i am pondering what else i should get done.
Shrink wrapping broken wire shielding, renew bad vacuum/water hoses.
What else would you suggest i get done?
 

jungle

3 AYC Bars
Lifetime Member
Location
QLD
First Name
Simon
Drive
1 PFL & 1 FL Legnum
I’d replace all the hoses while the engine is out. Much easier to get to and that should see you approximately 5 years before replacement again
 

veegeeta

Leaving Skid Marks
Lifetime Member
Location
qld
First Name
shane
Drive
fto with 6A13TT & bf xr6 turbo
I would put better rods in if it was me
 

AKKO

2 AYC Bars
Lifetime Member
Location
WA
First Name
Chris
Drive
1998 Galant VR4 Type-V (Facelift)
What's your budget for other things to check and or do?
 

Curt758

Idling at the Lights
Location
Saint lucia
First Name
Julian
Drive
1997 legnum ec5w
So while i have the engine out for crankshaft/Conrod bearing change,
i am pondering what else i should get done.
Shrink wrapping broken wire shielding, renew bad vacuum/water hoses.
What else would you suggest i get done?
Where did you source these parts from? Trying to find them myself
 
Top Bottom