http://www.ozvr4.com/forums/showthread.php?t=757 Following on from that thread: From the floor to the top of the boot opening is 770mm From the base of the high point on the back seats to the piece of plastic at the end of the boot is 1710mm From the back of the front seats in a normal seating position to the piece of plastic at the end of the boot is 1780mm. If you slide the seat all the way forward it goes up to about 1900mm If the back seats are upright you have 870mm at the top of the seats and about 1000mm at the bottom of the seats The full width right at the back is 1350mm The width between the wheel arches is 890mm The width between the elbow rests on the back seat is 1280mm Now the important question. Can someone with a Magna wagon, AU/BA Falcon, VT-VZ Commodore, and a Stagea take similar measurements? I'm sure that we have people here with the other Jap cars, I might need to pop down to a dealership and measure the Falcon and Commodore boots myself though. Oooh I wonder if I could get a measurement of the 300C, new 5 series (dame edna lights), old 5 series (e39) and maybe some other wagons too - any other suggestions?
went to a car dealer today, the space between the wheel arches on a commodore is 1200mm, and the depth of the wagon with the seats down is about 2100mm, depending on where the front seats are.
With a cargo barrier in the commo, i measured 900 high, 1450 wide (ignoring wheel arches) and 1150 deep
magna wagon these are rough as i was in a rush but.... 1385 full width 845 high 2000 from back of back seat to tailgate