Strengthening the automatic transmission on the cheap

koening

Idling at the Lights
Location
Poland
First Name
Michal
Drive
eclipse 3g
Hi guys, I replaced wavespring, my pump was good and I put back transmission to car. And nothing happen, my car wont drive. My car is Like on neutral even on drive "D"
 

Legnooms

Leaving Skid Marks
Premium Member
Location
Victoria
First Name
Tim
Drive
1998 Legnum Type-S VR4
2004 Ford Territory 4 sp Dual fuel
2006 Ford Territory 6 sp Dual fuel
Did you remember to bolt the selector back on, all electrical harnesses?
*and put enough ATF (proper spec) into the box and Torque converter?
 

ER1K

Idling at the Lights
Location
New Zealand
First Name
Eric
Drive
Mitsubishi Legnum VR4
Pin 1 pic only needs the 3 pins welded at one end because the other end of the pins are inside a hardened surface.
Pin 2 pic needs welding at both ends of each because both surfaces are just mild steel & all 6 holes will elongate. The 3 dowl pins won't be needed.
Pic 2 was a GTA runing E85 btw
Cheers - Aldo


How do you get to the pins on pic 2 under the right hand arrow? They are below a thin plate.

IMG20211004112724.jpg
 

BCX

Administrator
Moderator
Premium Member
Location
SA
First Name
Bill
Drive
2000 Galant Type-V
1997 MK Triton GLS [6G74 conversion]
2019 i30 N-Line
to reveal the other side, you need to pull the taper bearing off the shaft.
 

mookers

puri puri
Moderator
Premium Member
Location
Frankston, Melbourne, VIC
First Name
Derek
Drive
CL9 Accord Euro Lux, GE Jazz VTi, Evil Supervillain Chair, Homemade Portable Square Drumkit
Not sure if this has been posted here before, Mitsubishi bulletin regarding the valve body gasket being discontinued (and not actually necessary anyway it turns out.)
AT Valve Body Gasket Bulletin.jpg
 
Top Bottom