Is there anything that has to be done before welding on the chassis?
am mainly concerned about potentially frying electronics... but any general advice would be good too..
also are there any special welding consumables required? or will the "standard" mig wire/ MMA electrodes work? had previously read somewhere that some chassis are special alloys/high strength steels and dont want to use the wrong electrodes and cause more issues..
just want to weld a few little mounting tabs onto the chassis to mount some new hardware i'm working on, nothing structural.
am mainly concerned about potentially frying electronics... but any general advice would be good too..
also are there any special welding consumables required? or will the "standard" mig wire/ MMA electrodes work? had previously read somewhere that some chassis are special alloys/high strength steels and dont want to use the wrong electrodes and cause more issues..
just want to weld a few little mounting tabs onto the chassis to mount some new hardware i'm working on, nothing structural.