Will this eBay kit of control arms, tie rods and swaybar links fit the Legnums?

[wesleyong]

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=130300521203&viewitem=#ht_2281wt_824

SUSPENSION TALON SEBRING GALANT ECLIPSE 94-00 TIE BALL

$246 US, excluding postage. Ships worldwide, have emailed for quote.

Wes =)

 

[Guest]

If it does, your suspension will probably collapse shortly after, destroying the front end of the car. There have been a few reports of the aftermarket lower arms failing, so stick with the genuine Mitsubishi ones instead.

I just noticed you have already commented in the other thread about this today, so you can see there is plenty of discussion both here and on Club VR-4 about the ball joint failures.

 

[Guest]

It does depend on the manufacturer though and so far there have not been any negative reports on the arms from the States.

 

[jet150]

They should be fine.

I got my tie rod ends and sway bar links from the US $98AUS delivered compared to $130 a side in AUS. I think it was from the same seller to.

 

[wesleyong]

I will look into Mitsu prices for consideration.

Postage on that set was US$256. Ouch. But the seller made the item a bit cheaper in consideration for the postage. Item was just over $200.

The other item I am considering is
http://cgi.ebay.com/ebaymotors/ws/e...PageName=ADME:X:RTQ:MOTORS:1123#ht_1694wt_901
4 CONTROL ARM BALL JOINT TALON ECLIPSE SEBRING GALANT

$140 + $170 shipping = $310 US total

Anyone have any experience with this seller?

 

[whiteleg]

I got some lower control arms from these guys and they were fine.

 

[wesleyong]

Check it out guys, this seller offers FREE SHIPPING TO AUSTRALIA!!!

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=220414455776#ht_1115wt_901

Anyone dealt with the seller? Seller is autopropartner
$220US for the 4 lower front control arms.