Dropping front subframe

[Grid]

Any tips on how to do this with least effort? I have the rear rollstop center bolt removed, which should make it that much easier, and I need to drop the subframe to complete the rear rollstop replacement job.

Front-back crossmember and downpipes already removed.

 

[Size1]

I just cut down a 14mm long series socket to remove the rear roll stop from memory.

 

[Grid]

That works for one of the rollstop bolts, specifically the lower rear one. One of the rear two top ones is where I am having the issue. On a LHD conversion it collides with the engine harness and grommet.