Manual conversion help!!

[Gav]

Hi all so I need some help. Can someone that's done a auto to manual conversion please tell me exactly what parts I need to complete this and can anyone also offer any advice regarding doing the conversion. Any tips or advice would be great.
I do have a doner car that I'm taking the parts off.

 

[Vectose]

Just putting mine back together now.

Bits you need from donor car

Gearbox
Flywheel & adapter plates
Divider plate that goes between gearbox and engine
Clutch master cylinder, line and slave cylinder
Passenger side driveshaft
Passenger side inner shaft
Brake pedal
Clutch pedal
Clutch (if you aren't using a new one)
Shifter and cables
Gear surround
Cluster
Manual engine loom if you so desire
35mm hole saw for clutch master hole


You'll need a slide hammer to get the inner shaft out. I made one out of some threaded rod, nuts washers and galvanised pipe from Bunnings.

You need to make a template for drilling the hole for the clutch master cylinder.

You will also need to bypass the inhibitor switch wiring, hook up the reverse light wiring and possibly rewire the speed sensor if using the auto loom

 

[Gav]

Sweet. I'll use my auto cluster as it's the high vis one

 

[Nemesis]

was looking on ebay theres a manual box kit for 1900ish. Only been looking for 10 mins so not sure if thats cheap or not

 

[Gav]

full conversion minus clutch should sell for around 1400-1900

 

[Nemesis]

thanks mate i was looking at manual conversion costs and somehow ended up looking at varex mufflers on youtube lol

 

[Gav]

thanks mate i was looking at manual conversion costs and somehow ended up looking at varex mufflers on youtube lol

Just need to add on the labour of your getting a shop to fit it and add on $750-$800 for a good clutch off Steve