G
Guest
Unregistered
Does anyone know where exactly on the side of the block that factory oil pressure sender is located, and how much room there is around it?
From what I can gather it is located on the drivers side near the timing belt/pulley assembly area. I've stumbled across the following link, but can't seem to imagine in my head where exactly it's located on the motor...
http://www.mivec.co.nz/tech/6A1_Engine_Manual.pdf - (click on section 13 on the left, and its part number 1 which is located right below part number 21, on the left of the diagram).
Any photo's etc of the area?
Basically I'm looking at installing an oil pressure and oil temp gauge and "t-ing" them both into the one location for simplicity, which also will allow me to run an oil cooler later on down the track. I can't/don't want to run an oil filter adapter plate as my car is too low to run one of them and the oil filter sits low enough already and I really don't want to have to go to the hassle/expense of an oil filter relocation kit.
This is the "t" piece adapter I'm looking at, at the moment. I have asked the seller how long & wide it is so I can see if it will fit in the engine bay area of our cars.
http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=200575813377
From what I can gather it is located on the drivers side near the timing belt/pulley assembly area. I've stumbled across the following link, but can't seem to imagine in my head where exactly it's located on the motor...
http://www.mivec.co.nz/tech/6A1_Engine_Manual.pdf - (click on section 13 on the left, and its part number 1 which is located right below part number 21, on the left of the diagram).
Any photo's etc of the area?
Basically I'm looking at installing an oil pressure and oil temp gauge and "t-ing" them both into the one location for simplicity, which also will allow me to run an oil cooler later on down the track. I can't/don't want to run an oil filter adapter plate as my car is too low to run one of them and the oil filter sits low enough already and I really don't want to have to go to the hassle/expense of an oil filter relocation kit.
This is the "t" piece adapter I'm looking at, at the moment. I have asked the seller how long & wide it is so I can see if it will fit in the engine bay area of our cars.
http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=200575813377
