Kenneth
1 AYC Bar
So I am rewiring the loom. Got a fair bit of stuff all sorted, pulled a good portion of the protective wrapping/conduit off so that I can put some heat resistant sleeving on (wanted nicer result to just replacing the conduit).
Thought it would be a good idea to add some stuff to the loom for the future (standalone ECU one day, though I am half way tempted to wire it in now... the decisions!)
I won't necessarily be wiring the sensors up, but I want to make sure I have the additional wiring in place to handle what I might want to use in the future.
On my list so far:
On my list of maybes
These lists are essentially what I have sensors for right now.
Any ideas on additions?
Here is my current "progress"
Thought it would be a good idea to add some stuff to the loom for the future (standalone ECU one day, though I am half way tempted to wire it in now... the decisions!)
I won't necessarily be wiring the sensors up, but I want to make sure I have the additional wiring in place to handle what I might want to use in the future.
On my list so far:
- MAP sensor
- 3 Additional ignition outputs
- Additional knock sensor
- Additional O2 sensor input
- 2x IAT sensors (pre-post intercooler, separate turbo outlets or whatever... can't have too many of these)
- Water temp (for gauge)
- Oil Temp (for gauge)
- Oil pressure (for gauge)
- Pressure sensor (for boost gauge)
- Alarm siren wiring
On my list of maybes
- Thermocouple wiring (2 EGT, 2 CHT)
These lists are essentially what I have sensors for right now.
Any ideas on additions?
Here is my current "progress"