Removing Pins from ECU Loom Plug

pretzil

2 AYC Bars
Location
Qld
First Name
Rick
Drive
Legnum VR4
Hi guys,

Can someone please tell me what the trick is to removing pins from the ECU plugs? I need to move a spare pin (previously added by someone else0 to a different connector for dual map switching but can't figure it out.

I have already figured out about the big plastic latch, but can't figure out how to make individual pins release.

Here is what I am looking at:
ecu4.jpg
ecu3.jpg
ecu2.jpg
ecu1.jpg
 
I'm not sure.

I tried that quite a bit, in the end, the trick was to push a paper clip into this spot from the wire-side and wriggle a lot.

ecu1.jpg


I ended up doing this on the spare car's TCU loom, tried on the AYC loom but it uses different pins.
 
I greet you, friends, for my vision I need help. I purchased MD 340791 - JDM Legnum 25 ST and I want to download the firmware and flash my existing ECU EDM Galant W. Please help find the connectors or the ECU pins. Thank you in advance

MD 340791_conector.jpg
 
Top Bottom