Removing Pins from ECU Loom Plug

[pretzil]

Hi guys,

Can someone please tell me what the trick is to removing pins from the ECU plugs? I need to move a spare pin (previously added by someone else0 to a different connector for dual map switching but can't figure it out.

I have already figured out about the big plastic latch, but can't figure out how to make individual pins release.

Here is what I am looking at:

 

[naughtika]

i think you need to insert pins into the smaller holes at the front..

 

[pretzil]

I'm not sure.

I tried that quite a bit, in the end, the trick was to push a paper clip into this spot from the wire-side and wriggle a lot.

I ended up doing this on the spare car's TCU loom, tried on the AYC loom but it uses different pins.

 

[MatiLP640]

And who showed you this trick?

 

[Jozef Polak]

I greet you, friends, for my vision I need help. I purchased MD 340791 - JDM Legnum 25 ST and I want to download the firmware and flash my existing ECU EDM Galant W. Please help find the connectors or the ECU pins. Thank you in advance

 

[Jozef Polak]

Solved

 

[pretzil]

Solved

Please post your solution for people in the future...
Nothing worse than finding out someone had a similar problem 2 years ago and 'solved' it

 

[Jozef Polak]

This is the solution