- Thread starter
- #41
Yeah that's ok I know that it's not the first high comp motor ive built
not sure on cans yet aiming for bottom to mid rpm power so may use standard cans still
I was looking for 10.5:1 CR pistons have valve relief but may need increasing I'll get all parts and start checking clearances to see what needs to be done
I might go a bit higher but I'll get parts abs do some checks first
not sure on cans yet aiming for bottom to mid rpm power so may use standard cans still
I was looking for 10.5:1 CR pistons have valve relief but may need increasing I'll get all parts and start checking clearances to see what needs to be done
I might go a bit higher but I'll get parts abs do some checks first