bee r rev limiter

minxy74

Leaving Skid Marks
Location
NSW
First Name
Andrew
Drive
HJ Galant , CM5A GSR (project)
hey guys i need to know which pins on the ecu i need to connect a bee r rev limiter too. it needs crank angle which is sorted, and igniter signal can anyone help
 
They usually only work if you have de catted. But the rev limiter and launch control is auraly orgasmic.
 
You can get that now with the launch control that Steve offers cant you?
 
hey guys i need to know which pins on the ecu i need to connect a bee r rev limiter too. it needs crank angle which is sorted, and igniter signal can anyone help

our ignition systems dont have an ignitor... the three coil packs are earthed in the ECU (each coil pack has it's own internal power transistor and protection diode). Depending on what kind of signal it's looking for, you might be able pinch from one of the coil signals.

are you sure it needs CAS instead of a tacho signal? if your actually after a tacho signal, your best to pinch it from the Ignition Failure Sensor wire. (pin 58)

Hope this helps.

Cheers,
Bill
 
Yep stationary rev limiter with different fuel and ignition is entirely possible.
 
Can it throw flames though thats what i want. if u can do it without it i will put it onn my mirage instead

Yep stationary rev limiter with different fuel and ignition is entirely possible.
 
Hmmm, havent tried, ill have a go :)
 
Remove the cat or you'll blow a hole through somewhere in your exhaust. Or the internals of the cat will melt.

Also get familiar with changing spark plugs.
 
Top Bottom