rev limiter install - HELP!

[Guest]

Hi guys,
Just had a BEE*R rev limiter installed however mechanic needs to wire up the unit to the 120degree ignition signal does anyone know where this is and how I can get access to a diagram? We’ve already looked on the pin diagrams found on here but none of them have this one there.
HELP! =]

 

[leebutts]

Whats the point of an aftermarket rev limiter? Our cars are out of puff well below the factory redline anyway...

I don't know what a 120degree ignition is so I can't help you

 

[pu-11-me]

It might have launch control Lee

Sorry but I don't know the answer to the question being asked

 

[Guest]

in answer to your question Lee, because I can and the youtube video's look rad.

 

[Guest]

hopefully it works!

 

[smohekey]

The 120 degrees signal will be the crank angle sensor. It has three teeth so should pulse every 120 degrees. I don't know off hand which wire this is in the ECU plug set, but there is a pinout thread on here somewhere which will tell you.

 

[unclepaulie]

vroom vrooommm pssht vrooommm bang bang bang bang bang bang!!!!!!

id hav this just to hurry people up in carparks and zebra crossings haha

 

[Guest]

haha. yeah i'm not sure if lee actually knew what i was talking about...

see below:

http://www.youtube.com/watch?v=2SQGcwmrJTw&feature=related

thanks smohekey!

 

[Kitty's VR4]

Shamren,

try here

Connector C-39, pin #19

 

[king_panther]

You put an after market exhaust on & doesn't it let you blow flames out ?

I've been looking at one just for that feature..

 

[Guest]

yeah it does. i already have the exhaust so hopefully it flames like a trooper! =]

ALSO, the launch control feature is sweet! (DAWSO)
thanks kitty.

 

[unclepaulie]

bye bye turbo internals tho

 

[leebutts]

haha. yeah i'm not sure if lee actually knew what i was talking about...!

Well know I know, still seems like a waste of money to me