naughtika
OzVR4 Stalker
just provide them your current spacer.. tell them to make you something similar but of course with the length that you're after..
Voltage | Latency |
4.6875 | 5.544 |
7.03125 | 3.36 |
9.375 | 2.208 |
11.70875 | 1.584 |
14.0625 | 1.224 |
16.40625 | 1.008 |
18.6767578125 | 0.84 |
Akko, I have the dimensions you need for the sard 650s, I have to get some spacers made for another car do do you wasn't me to get an extra 4?
Hi Kenneth, would you mind advising what fuel brand and type you are running?
The plugs don't match but that's fine because new plugs and pins came with and these's no need to solder.
The injectors I've ordered are specifically for a 3000GT with JDM clips & plugs.
Pictures or it didn't happen!Chris,
I recently installed the ID1000's (Steve is tuning it this weekend) with the pigtails. Now I cut, soldered, heat shrinked and also used high heat wire tubing to maintain a factory look. Not too hard to do with a bit of time, and basic soldering skills. As for the injector fit, straight in with the stock rail spacers (I did use a second rail o ring on each injector due to the design).
The Denso plug looms were about $20ea, and I thought they would clutter the engine bay a bit, so I went the pigtail route, so everything looks neat and stock.