naughtika
OzVR4 Stalker
Evo 7 injectors - I know a remap is needed - but electrically and mechanically speaking they are plug and play?
i think he's also using evo injector resistors - modded i think?!
Evo 7 injectors - I know a remap is needed - but electrically and mechanically speaking they are plug and play?
The previous combo if its for street is much better.
This one is down everywhere except above 6000rpm.
@6000 it gets in front but that can't make up,for the deficit everywhere else!
At times it's ~110hp
FROM 4000-5000itsm70-110hp behind.
I'd prefer the previous combo
did you used the stock monifordsVR4 single turbo conversion in the making
2 rear manifolds ported to 2'' outlet
2'' stainless steel runners
tial 44mm external wastegate
t3t4 60 trim garrett turbo/A/R 63 turbine housing
so how did the oil drain of wok you put them in 1 r what you didYes bro I use 2 rear manifolds so the front would be facing upwards also the trick is you need to port the outlet to 2" so this would flow a whole lot better
How did you extend and re route your water lines ect to the throttle body on the other side?end results...
By coating/wrapping the mainfolds and downpipe and creating heatsheilds where necessary.How do you isolate all the wires from the heat? Can you take a picture next time?
yes 2" OD all the way dont go any biggerAm just about to start this in the fto but unfortunately I have to leave the throttle body where it is I can't fit it on the other side. I'm getting the bits I need together now. I will use 2 rear manifolds for it honed out to 2 inch. What size pipe did you use coming of the standard manifold's to join together, was it 2inch all the way?